Grass Valley 8985FS v.1.3.2 - Manual (Page 42)

42 8985FSP/FS — Instruction Manual
Configuration
System Config Web Page
Use
this
link
Use the System Config web page ( Figure 22 on page 44 ) to monitor and set
the following system configuration parameters for the module:
Video I/O Configuration
• Ref Input – the reference input standard selected on the Genlock web
page (Genlock Web Page on page 59 ) is reported in this read-only field.
• Input Standard – select the video input standard and frame rate selection
from the Input Standard pulldown from the following choices:
• Auto – module will auto-sense input type
• 480i– (SD 59.94)
• 576i–(SD 50)
• 720p–(HD 59.94)
• 1080i–(HD 59.94)
• 720p–(HD 50)
• 1080i–(HD 50)
• 1080p–(HD 24)
• 1080sf–(HD 24)
Note The input video standard must be set to the same frame rate (or compatible
frame rate as listed in
Table 3 on page 45 ) as the reference input when the
input video is associated with the reference input in the Output Timing con-
trols for proper genlocking.
When a new selection is made in the Inputs Standards pulldown, a Changes
Pending message will appear ( Figure 19 ). Click the Apply Setting s button to
make the change.
Figure 19. Changes Pending Message