Grass Valley 8985FS v.1.3.2 - Manual (Page 23)

8985FSP/FS — Instruction Manual 23
Power Up
Power Up
The front LED indicators and configuration switches are illustrated in
Figure 8 . Upon power-up, the green PWR LED should light and the yellow
CONF LED should illuminate for a few seconds for the duration of module
initialization. The on-board configuration switches are not used on these
modules.
Note When a media module is first plugged into a GeckoFlex frame, the 8900NET
module (if present) may report a momentary fault. This will clear once the
media module has booted up.
Operation Indicator LEDs
With factory default configuration and a valid input signal connected, the
green PWR and (
Figure 8 ) on the top side of the module front edge should
illuminate (refer to Table 2 on page 24 to see the possible operating indi-
cator combinations).
Figure 8. Front Panel LED Indicators