Grass Valley 8985FS v.1.3.2 - Manual (Page 19)

8985FSP/FS — Instruction Manual 19
Installation
Optional Fiber Optic Submodule Installation
After the front and rear modules have been installed, install the SFP Fiber
Optic submodule option if being used into the rear module metal cage
labeled FIBER (
Figure 6 on page 20 ). The SFP submodule is hot-pluggable
and may be installed or removed with power applied to the module.
CAUTION Use anti-static precautions and handle the submodule carefully when
installing and the removing it. Before inserting the fiber cable, it is important
to clean all fiber connections as described in Fiber Optic Cleaning Require-
ment below.
Refer to Table 1 for the correct model of submodule to use with different
software versions.
Fiber Optic Cleaning Requirement
Before making any fiber optic cable mating connections, including installa-
tion, and after every de-mating cycle, use an industry standard fiber optic
cleaning kit, including oil-free compressed air, to clean the fiber connectors
and the connectorized fiber end faces. This helps ensure optimum perfor-
mance of the fiber optic interface. Industry standard fiber optic cleaning
kits can be purchased on the web and in electronics stores.
Table 1. Fiber Optic Submodule Summary
Submodule Type SW 1.3.2 and later SW 1.3.2 and earlier
SFP-13103G-M1DRX Dual Receiver X –
SFP-13103G-M1DTX Dual Transmitter X –
SFP-13103G-M1TRX Transceiver X –
1310nm-DRL Dual Receiver X X
1310nm-DTL Dual Transmitter X X
1310nm-TRL Transceiver X X