Grass Valley 8921ADT - Manual (Page 41)

8921ADT Instruction Manual 41
Configuration
To load a saved file from a location outside of the frame:
1. Select the Load from ... button under File Operations in the Current or
E-MEM row.
This will bring up the Load Current Config page ( Figure 18 ) or the Load
E-MEM page (not shown).
2. Browse to the location of the file you wish to load and select the file.
Select the
Open button to load the file or enter the filename and path in
the Enter filename box.
3. Once the correct path and filename is loaded, select the Load button on
the Load Current Config or Load E-MEM page.
4. This will place the recalled configuration from the file into the module.
The
Last Recalled E-MEM field will report File .
Figure 18. Load Current Config Page
Recall Defaults
Default settings for the module can be recalled by selecting the Recall
Defaults button on the main E-MEM page. The defaults will revert to the set-
tings given in the Default column in Table 4 on page 22 . The Last Recalled
E-MEM field will report Default .
Note Default settings for Sample Rate, AES Output Resolution, and Output Pro-
cessing Mode will match the hardware jumper settings made in
Module
On-board Jumper Settings on page 8 during installation. Default settings for
the AES 1 and AES 2 output processing modes will match the setting on the
AES 1 and AES 2 rotary switches on the front of the module.