Grass Valley 8921ADT - Manual (Page 20)

20 8921ADT Instruction Manual
Configuration
Gain Adjustments
Once the output mode for each AES output has been selected, the gain of
the outputs can be adjusted from – 40 to + 6 dB in the audio processor as
required. Each output can be adjusted individually or locked together in
two groups, AES 1 A and B, and AES 2 C and D.
AES Output Resolution
The output resolution for AES 1and AES 2 can be set to either 20 or 24 bits.
This is set locally during installation with on-board jumpers J13 (AES 1)
and J14 (AES 2). The jumper settings can be overridden with the remote
controls.
Output Sample Rate
The output sample rate for both AES 1and AES 2 will always default to
48 kHz for this release.
Auto Tracking
If an external tracking signal is connected to the module, the TRK IN BNC,
J11, must be jumpered on the module as an input with jumper J5 (see
Module On-board Jumper Settings on page 8 ). Auto tracking must also be
enabled with local or remote controls.