Grass Valley 8921ADT - Manual (Page 27)

8921ADT Instruction Manual 27
Configuration
Set Output Processing Modes
Two rotary switches are provided on the front edge of the module for
setting the desired output mode for AES 1 (SW1) and AES 2 (SW2). Refer to
Output Processing Modes on page 18 for an overview of each mode.
Bank 2 (BANK 2 LED on)
Bank 2 (BANK 2 LED on)
0 – – Default position for normal operation (paddle has no effect).
1 Increase Decrease Adjust output gain of both Ch A and Ch B of AES 1 together. 1
2 Increase Decrease Adjust output gain of both Ch C and Ch D of AES 2 together. 1
3 Increase Decrease Adjust output gain of Ch A of AES 1.
4 Increase Decrease Adjust output gain of Ch B of AES 1.
5 Increase Decrease Adjust output gain of Ch C of AES 2.
6 Increase Decrease Adjust output gain of Ch D of AES 2.
7 Increase Decrease Delay Ch A output of AES 1 separately.
8 Increase Decrease Delay Ch B output of AES 1 separately.
9 Increase Decrease Delay Ch C output of AES 2 separately
A Increase Decrease Delay Ch D output of AES 2 separately.
B Increase Decrease Delay both channels of AES 1 output together.
C Increase Decrease Delay both channels of AES 2 output together.
D-E – – Not used.
F Recall – Recall defaults as given in Bank 1, position F.
1 Preserves gain offsets between channels.
Table 6. AES 1 and AES Modes Switch Settings
Position AES 1 Processing Mode AES 2 Processing Mode
0 A, B (Pass) C, D (Pass)
1 – A, – B – C, – D
2 – A, B – C, D
3 A, – B C, – D
4 A + B (– 6 dB) C + D (– 6 dB)
5 A + B, A–B (MS D/E) C + D, C–D (MS D/E)
6 – (A + B) – (C + D)
7 1 kHz 1 kHz
8 400 Hz 400 Hz
9 Silence Silence
A A + B, C C, D (Pass)
B A + B, D C, D (Pass)
C-D A, B Pass C, D (Pass)
E A/B ID C/D ID
F A, B (Pass) C, D (Pass)
Table 5. CONTROL Rotary and Paddle Switch Functions
Rotary
Switch
Setting
Paddle
Switch Up
Paddle
Switch Down
Function Description