Grass Valley 8921ADT - Manual (Page 21)

8921ADT Instruction Manual 21
Configuration
Reference Source
The module can lock to an external reference or free run. The reference
source can be selected with local or remote controls. If a reference signal is
connected to the loop-through input, the reference source should be set to
Reference In . If no external reference is used, or you don not wish to have the
module lock to its reference input, set the module to Free Run .
Recalling Factory Defaults
When the factory defaults are recalled with either the local controls or the
remote control from the web page, the module will revert to the following
values:
• Maximum input levels to + 24 dBu
• Output gains to 0 dB
• Delay to 0 sec
• Input mapping to Inputs 1, 2 = AES 1 A, B, Inputs 3, 4 to AES 2 C, D
The following controls will default to the current on-board jumper and
rotary switch settings on the module:
• Sample Rate – jumper J12 is set for 48 kHz, the current default for this
release.
• Output Resolution – will default to the jumper setting for 20 or 24 bit
word length on jumper J13 for AES 1 and jumper J14 for AES 2.
• Output processing mode – will default to the rotary switch setting on
rotary switch SW1 for AES 1 and SW2 for AES 2.