Grass Valley 8921ADT - Manual (Page 38)

38 8921ADT Instruction Manual
Configuration
Audio Proc Page
The Audio Proc page ( Figure 15 ) reports the following for each AES output
channel:
• Presence of audio input signal (True = > – 40 dBFS)
• Clip status of audio input signal (True = > – 0.5 dBFS)
Use the Audio Proc page to make the following adjustments:
• Processing – set the output processing mode for AES 1 and AES 2 from
the corresponding Processing pulldown. Refer to
Output Processing
Modes on page 18 for an overview of each output processing mode.
Note Also set the on-board AES1 and AES2 Mode rotary switches on the front of
the module to match your settings. Refer to
Set Output Processing Modes on
page 27 . If defaults are recalled, the module will default to the local settings.
• AES Output Resolution – set the output resolution to 20 or 24 bit for
AES 1 and AES 2. This setting will override the on-board settings made
at jumpers J13 and J14 (
Table 1 on page 8 and Figure 1 on page 9 ).
• Gain – adjust the output gain in dB for each channel with the corre-
sponding
Gain controls.
Output gains can also be adjusted in pairs (AES 1 A and B, AES 2 C and
D) by selecting the corresponding
Locked checkbox in the Gain Locking
area and adjusting either Gain control in the pair.
• Output Sample Rate – the default output sample rate for AES 1 and
AES 2 of
48kHz will be reported (read only).
Figure 15. 8921ADT Audio Proc Page
Use
this
link