Grass Valley LDK 4410 - Manual (Page 59)

LDK 4410 + LDK 5420 3G Fiber Transmission System User’s Guide (v1.0) 59
Chapter 5 - Menus
Audio ip mode Ch1, Ch1&2 Selects audio input mode: Channel 1 or
Channel 1 and 2 (Only when a Wireless
adapter is installed) User 1 Oper
Audio Gain Mode Loc, Ext Selects audio gain mode:
Loc: audio gain levels is controlled by the
camera (local);
Ext: audio gain level is controlled by the
base station (external). User 1 Oper
Audio 1 Source Line, Mic, Mic48, Front Selects source for audio channel 1 (Only
when a Wireless adapter is installed) User 1 Oper
Audio 1 Level -22dB, -28dB, -34dB, 
-40dB, -46dB, -52dB, 
-58dB, -64dB
Sets input gain level for audio channel 1
(when audio gain mode is set to local). User 1 Oper
Audio 1 HPF Off, On Turns high-pass filter for audio channel 1 on
or off. Use to reduce 50 Hz and 60 Hz hum
or low frequency noise. User 1 Oper
Audio 2 Source Line, Mic, Mic48, Front Selects source for audio channel 2 (Only
when a Wireless adapter is installed) User 1 Oper
Audio 2 Level -22dB, -28dB, -34dB, 
-40dB, -46dB, -52dB, 
-58dB, -64dB
Sets input gain level for audio channel 2
(when audio gain mode is set to local). User 1 Oper
Audio 2 HPF Off, On Turns high-pass filter for audio channel 2 on
or off. Use to reduce 50 Hz and 60 Hz hum
or low frequency noise. User 1 Oper
Tally
Onair Lamp Enable, Disable Select enable when the tally light at the
front of the 7-inch viewfinder has to follow
the tally signal; select disable if you never
want it to light. User 0 Oper
Tally Lock Off, On Turns tally lock function on or off. When
tally lock is on, some camera controls are
locked when camera is on air. User 3 -
Reverse Scan
Reverse Scan Off, On Turns reverse scan on or off. User 0 Scene
Mode Horiz, Vert, Both Selects reverse scan mode:
Horiz = the image is flipped horizontally;
Vert = the image is flipped vertically;
Both = the image is flipped both horizontally
and vertically. User 0 Scene
Exposure
Lighting -10..+10 (0) Sets the exposure correction to fine-adjust
for ambient lighting frequency when
exposure mode is 50 Hz or 60 Hz. User 1 Scene
Clean Scan
Cl.Scan Mode Extended, Normal Selects clean scan mode:
Normal (VAR2 on OCP/MCP) = shutter is
running (no smear);
Extended (VAR1 on OCP/MCP) = shutter is
not running (more accurate clean scan but
possible vertical smear). User 1 -
Install Values Description Level File