Grass Valley LDK 4410 - Manual (Page 23)

LDK 4410 + LDK 5420 3G Fiber Transmission System User’s Guide (v1.0) 23
Chapter 2 - Base station
H-Phase adjustment
When “HP” is displayed, push the rotary/push button to enter the H-Phase
adjustment mode. Rock the button to the left or right to shift the H-Phase. If you
continue to rock the button, the shift change occurs in bigger steps. Push the rotary/push
button again to leave the H-Phase adjustment mode.
☞
Note
☞
Note
This item is only available when a reference signal is present.
2.2.2 Using the OCP
The OCP can be used access the base station menu instead of the rotary/push button.
1. Push the Setup button on the OCP to open the menu.
2. Push the selection button to choose the BS menu.
3. Push the selection button enter the Menu
4. The menu appears on the Monitoring and CVBS + Text outputs of the base station. Use
the appropriate selection buttons to navigate the menu. You can also use the rotary contol
on the OCP to move up or down through the menu.
Diag OCP
BS Cam
EXIT
PREV
TOGGLE
NEXT
Menu
EXIT
PREV
TOGGLE
NEXT
UP
DOWN SELECT
EXIT
PREV
TOGGLE
NEXT