Grass Valley LDK 4410 - Manual (Page 22)

22 LDK 4410 + LDK 5420 3G Fiber Transmission System User’s Guide (v1.0)
Chapter 2 - Base station
2.2 Base station menu
The base station can be set up using either:
• The rotary/push button on the data board inside the base station or
• An Operation Control Panel (OCP) connected to the base station.
2.2.1 Using the rotary/push button
Push the two clasps at the bottom of the front cover upward and remove the front cover to
access the inside:
Locate the rotary/push button on the data board at the left. Rock the button to the left or right
to select the required item. The segment display shows the code of the selected item.
☞
Note
☞
Note
When accessed from the base station, the user level is set to Install.
There are three items that can be selected:
Base station menu
When “NN” is displayed, push the rotary/push button twice to enter the base
station menu. The rotary/push button can be used to navigate through the menu.
The menu appears on the Monitoring and CVBS + Text outputs of the base station.
Camera number
When “CA” is displayed, push the rotary/push button to enter the selection mode.
Rock the button to the left or right to select an available camera number. Push the
rotary/push button again to confirm the new camera number. The base station automatically
resets and the new camera number is shown in the display.
Camera Communication On Air Base Station Ready Mains Camera
Power On
Test Connected
Open
clasp
Open
clasp
Front
cover
Segment
display
Rotary/push
button