Grass Valley 2031RDA-MM - Manual (Page 9)

2031RDA-SM/-MM Instruction Manual 9
Installation
Figure 2. 2000T1DNG Frame, Rear View
2. Install the module by inserting it into any rear slot of the frame as
illustrated in
Figure 3 .
3. Verify that the module connector seats properly against the midplane.
4. Secure the module to the rear of the frame with the two screw locks on
either side of the back panel using a crossblade screwdriver.
Figure 3. Installing 2031RDA-SM/-MM Module
8318_09
Media section
rear slots 1-2
(with one 2000EMI blank)
J101
1
2
3
4
J102
Media section
rear slots 3-4
Network
and reference
input connections
Power connections
J10
IN
J9 SIG J8 J6 J7 J5 J4 J2 IN OUT
FIBER IF
J3
2031RDA
-MM
J1
Alignment post
and receptacle
Screw lock
(both sides)
8318_01
2000 frame (rear view)
Board edge guides
(both sides)