Grass Valley 2031RDA-MM - Manual (Page 31)

2031RDA-SM/-MM Instruction Manual 31
Specifications
Specifications
Table 4. 2031RDA-SM/-MM Specifications
Parameter Value
Serial Digital Component Coax Input
Number and type of inputs 1 BNC
Input impedance 75 Ohm
Return loss > 15 dB from 5 MHz to 540 MHz
Signal type, auto-equalizing only 50 Mb/s to 540 Mb/s: rise/fall time – 20 to 80%, 400-800 ps,
signal level – 800 mV ± 10%)
Signal type, auto-equalizing and reclocking SMPTE 259M-1997 with the following bit rate tolerances:
143 Mb/s ± 5%
177 Mb/s ± 5%
270 Mb/s ± 5%
360 Mb/s ± 5%
ETSI TR 101 891v1.1.1 (DVB-ASI) with the following bit rate tol-
erance: 270 M/b/s ± 5%
SMPTE 344M-2000 with the following bit rate tolerance:
540 Mb/s± 5%
Auto equalization cable lengths
(for any of the above signal types) Up to 300 m of Belden 1694A cable for bit rates up to 270 Mb/s
Up to 100 m of Belden 1694A cable for bit rates > 270 Mb/s and
< 540 Mb/s
Input jitter tolerance ≥ 1 UI p-p from 10 Hz to 200 Hz
≥ 0.2 UI p-p from 200 Hz to 15 MHz
Serial Digital Component Fiber Input
Connector LC (1 input)
Fiber types 2031RDA-MM: multimode complying with
ANSI/TIA/EIA-492AAAA-A (maximum attenuation of 1.5 dB per
kilometer at 1310 nm)
2031RDA-SM: singlemode complying with
ANSI/TIA/EIA-492CAAA (maximum attenuation of 1.0 dB per kilo-
meter at 1310 nm)
Wavelength 1270-1355 nm
Input power 2031RDA-MM: -28 dB (minimum) to -7.5 dB (maximum)
2031RDA-SM: -20 dB (minimum) to 0 dB (maximum)
Signal type Same as Signal type, auto-equalizing only and Signal type,
auto-equalizing and relocking above
Fiber length 2031RDA-MM: 2 kilometers minimum at 270 Mb/s
2031RDA--SM: 7 kilometers minimum at 270 Mb/s
Jitter (on any specified signal type) > 0.2 UI p-p, 10 Hz to 10 MHz
Serial Digital Component Coax Outputs
Connector BNC (8 outputs)
Output impedance 75 Ω
Return loss > 15 dB from 5 MHz to 540 MHz
Signal level SDI 800 mV p-p, ± 10% maximum
Rise/fall time 400-800 ps
Output polarity Non-inverted
Output jitter < 0.2 UI p-p