Cabling, Electrical input, Electrical outputs – Grass Valley 2031RDA-MM User Manual
Page 10: Fiber input, Fiber output
10
2031RDA-SM/-MM Instruction Manual
Installation
Cabling
Cabling to the 2031RDA-SM/-MM module is done on the BNCs and the
fiber connector on the rear of the module. Refer to
illustration of the rear connections referenced below.
The input can be either electrical or fiber optic and the desired input must
be enabled using an on-board jumper or with remote controls. The outputs
can be both electrical and fiber optic. The fiber optic output must be
enabled using an on-board jumper or remote controls.
For configuration, refer to
.
Electrical Input
Connect an SDI electrical video input to BNC J10. This input must be
enabled for use during configuration.
Electrical Outputs
Connect electrical video destinations to any of the eight outputs at connec-
tors J1, J3– J9. Terminate any unused outputs. These outputs are always
active and do not need to be enabled.
Fiber Input
Connect a fiber input to the right side of the FIBER IF connector J2. This
input must be enabled for use in configuration.
Fiber Output
The fiber output is available on the left side of the FIBER IF connector J2.
This output must be enabled for use in configuration.
Figure 4. 2031RDA-SM/-MM Input/Output Connectors
IN
OUT
FIBER IF
8318_02
SDI In
SDI Out 2-8
SDI Out 1
SIG LED
Fiber In
Fiber Out
IN
OUT
OUT
OUT
OUT
OUT
OUT
OUT
OUT
J10
J9
SIG
J8
J7
J6
J5
J4
J3
2031RDA
-MM
J2
J1