Grass Valley 2031RDA-MM - Manual (Page 16)

16 2031RDA-SM/-MM Instruction Manual
Configuration and Monitoring
Remote Configuration and Monitoring
Configuration and monitoring can be performed using a web browser GUI
interface or a networked Newton Control Panel when the 2000NET
Network Interface module is present in the video frame. Each of these
interfaces is described below.
2000NET Module Information
Refer to the 2000NET Network Interface Module Instruction Manual for
information on the 2000NET Network Interface module and setting up and
operating the Kameleon 2000 frame network.
Newton Control Panel Configuration
A Newton Control Panel (hard or soft version) can be interfaced to the
Kameleon 2000 Series frame over the local network.
Note For Newton control of this module, the 2000NET module in the frame must
be running software version 4.0.0 or later.
Control panel access offers the following considerations for module config-
uration and monitoring:
• Ability to separate system level tasks from operation ones, minimizing
the potential for on-air mistakes.
• Ability to group modular products—regardless of their physical loca-
tions—into logical groups (channels) that you can easily manipulate
with user-configured knobs.
• Update software for applicable modules and assign frame and panel IP
addresses with the NetConfig Networking application.
• Recommended for real-time control of module configuration parame-
ters, providing the fastest response time.
Note Not all module functions are available with the control panel, such as factory
default recalls. The available control panel controls for the module are listed
in
Table 3 on page 13 .
An example of the Newton Configurator is shown in Figure 7 on page 17 .