Grass Valley 2000NET v4.0.0 - Manual (Page 50)

50 2000NET Instruction Manual
Using the 2000NET GUI
2000NET Network Web Page
After initial frame network addressing is done using the RS-232 port, sub-
sequent address changes may be made using the Network Parameter entry
fields on the 2000NET Network web page illustrated in
Figure 32 .
The 2000NET module must be rebooted before changes will take effect. You
can reboot the module from the Network web page by clicking the
reboot
button. The reboot button can also be found on the Configuration web page.
Figure 32. Configuring the 2000 Network
Note SubNet Mask and Gateway IP Address are required.
Use
this
link
Frame
Machine
Address
Enter and Apply
Network
Parameters