H3C Technologies H3C SecPath M9000 Series - Manual (Page 31)

23
Connecting power cables
WARNING!
Before you connect the power cable to a power module, make sure the circuit breaker is switched off.
Connecting an AC power cable
1. Insert the power cable plug into the power receptacle of the power module.
2. Use a cable tie to secure the power cable to the cable management bracket.
3. Plug the other end of the power cable to the AC power receptacle of the power source.
Figure 23 Securing the AC power cable (M9006)
Connecting a DC power cable
1. Insert the power cable plug into the power receptacle of the power module.
2. Fasten the screw to secure the power cable.
Figure 24 Connecting the power cable (M9010)
(1) Insert the power cable plug into the power module (2) Fasten the screw
3. Use a cable tie to secure the power cable to the cable management bracket. For more information,
see Figure 23 .