H3C Technologies H3C SecPath M9000 Series - Manual (Page 21)

13
Attaching air filters to an M9006/M9014 gateway
Air filters of an M9006/M9014 gateway are installed at the left of the chassis. The air filter installation
procedures on an M9006 and M9014 are the same.
To install an air filter on an M9006/M9014 gateway:
1. Put the air filter near the air inlet vents on the left of the chassis and insert the poisoning pins on the
air filter into the corresponding holes on the chassis.
2. Insert the screws into the screw holes on the air filter, and fasten them with a Phillips screwdriver.
Figure 11 Attaching air filters to an M9006 gateway
Attaching air filters to an M9010 gateway
The air filter of an M9010 gateway is installed at the lower part of the chassis front.
To install an air filter on an M9010 gateway:
1. Put the air filter near the air inlet vent on the lower part of the chassis front and insert the poisoning
pins on the air filter into the corresponding holes on the chassis.
2. Insert the screws into the screw holes on the air filter, and fasten them with a Phillips screwdriver.
1
1
2
2