Upgrading the bootware program – H3C Technologies H3C SecBlade SSL VPN Cards User Manual
Page 34
28
Figure 15 Sending file dialog box
After the file is downloaded, the following information is displayed on the configuration terminal:
Download successfully!
10129792 bytes downloaded!
NOTE:
•
The size of an application is often over 10 MB. Even if the baud rate is set to 115200 bps, it usually takes
about 30 minutes to upgrade the application through the serial interface. Therefore, you are
recommended to upgrade applications through an Ethernet interface.
•
If you want the SecBlade card to use the downloaded file, you need to specify the file for the next boot.
For related information, see “
” on page
Upgrading the BootWare Program
Select 7 on the main menu (see “
) to enter the BootWare operation submenu,
where you can perform all operations related to the BootWare program. For more information about the
BootWare operation submenu, see “
.
The following example shows how to upgrade the entire BootWare program:
1.
Modify the baud rate of the serial interface to improve the upgrade speed (for more information,
see “
Modifying Serial Interface Parameters
” on page
) and then select 3 on the BootWare
operation submenu. The following information is displayed:
===========
| <1> Update Full BootWare |
| <2> Update Extended BootWare |
| <3> Update Basic BootWare |
| <4> Modify Serial Interface Parameter |
| <0> Exit To Main Menu |
=============================================================
Enter your choice(0-4):