H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 73)

65
• Upgrading the BootWare and application files by using TFTP or FTP through an Ethernet port
NOTE:
•
The BootWare program is upgraded together with the application program. The system automatically
upgrades the BootWare program when you upgrade the application program.
• Before upgrading the software of your access controller, check the current BootWare version and
application program version to make sure that the correct file is used for the upgrade. For the association
between the host application program version and BootWare version, see the hardware and software
compatibility matrix in Release Notes.
BootWare menus
BootWare main menu
Upon access controller power-on or reboot, the console terminal connected with the access controller first
displays the following information:
System start booting...
Then, the following information appears:
Booting Normal Extend BootWare....
The Extend BootWare is self-decompressing..............
Done!
****************************************************************************
* *
* H3C WCMB BootWare, Version 1.18 *
* *
****************************************************************************
Copyright (c) 2004-2010 Hangzhou H3C Technologies Co., Ltd.
Compiled Date : Sep 13 2010
CPU Type : BCM1125H
CPU L1 Cache : 32KB
CPU Clock Speed : 600MHz
Memory Type : DDR2 SDRAM
Memory Size : 1024MB
Memory Speed : 166MHz
BootWare Size : 512KB
cfa0 Size : 259MB
CPLD Version : 010
PCB Version : Ver.F
BootWare Validating...
Press Ctrl+B to enter extended boot menu..
NOTE:
The extended boot menu is referred to as BootWare main menu in this document unless otherwise stated.
At the prompt above, press Ctrl+B. The system prompts you to enter the BootWare password:
Please input BootWare password: