H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 55)

47
Software maintenance
NOTE:
•
This chapter uses an EWPX1WCMB0 as an example to display the output information. If the output is
different on an EWPX1WCMB0 and EWPX1WCMD0, the chapter will describe it separately.
• For how to upgrade the applications through BootWare, see the chapter “Software maintenance
through the BootWare menu.”
The following approaches are available for upgrading application files:
• Upgrading application files through the web interface
• Uploading application files at the CLI
Upgrading applications through the web interface
The access controller supports the web management function. You can use the web interface to manage
and maintain your access controller.
Setting up a web configuration environment
1. Set up a web configuration environment, as shown in Figure 41 .
You can set up a web configuration environment in one of the following methods:
• Connect the Ethernet interface on the switch interface board of the access controller to the PC, and
make sure that the PC and the access controller can reach each other.
• Connect the management Ethernet interface on the access controller to the PC, and make sure that
the PC and the access controller can reach each other.
The first method is used in the example. The second method is simple. You only need to configure an IP
address for the management Ethernet interface, and make sure the PC and the management Ethernet
interface can reach each other.
Figure 41 Set up a web configuration environment
2. Configure the IP address of VLAN-interface1 on the main control board of the access controller as
192.168.0.100/24.
system-view
[H3C] interface Vlan-interface 1
[H3C-Vlan-interface1] ip address 192.168.0.100 24
[H3C-Vlan-interface1] quit
3. Configure the username, password, and user privilege level for logging in to the main control
board.