H3C Technologies H3C WX6000 Series Access Controllers - Manual (Page 20)

12
Optical Gigabit Ethernet ports
The board provides four optical GE ports, which are combo ports. When these ports are in use, the
corresponding electrical ports (ports 21 through 24) cannot be used.
Table 12 Technical specifications for the optical GE ports
Item Specification
Connector type LC
Number of interfaces 4
Interface speed 1000 Mbps, full duplex
Supported optical fiber modules 1000BASE-SX SFP/1000BASE-LX SFP
Functions Data exchange
10 GE interface module
The switch interface board provides a one-port or two-port 10 GE interface module for high-speed data
exchange with switching equipment. For more information about the 10 GE interface module, see 10GE
XFP Interface Module for WX6103 Access Controller Installation Guide.
LEDs on the switch interface board panel
Table 13 Description of LEDs on the switch interface board panel
LED Status Description
GE port LED (electrical
combo port LED) LINK/ACT
yellow/green
• Steady yellow—a 10/100 Mbps link is present.
• Steady green—a 1000 Mbps link is present.
• Blinking yellow—port is in 10/100 Mbps ACT
state, and data is being transmitted/received.
• Blinking green—port is in 1000 Mbps ACT state,
and data is being transmitted/received.
• Steady off—no link is present.
Optical combo LED Green/yellow
• Steady green—a 1000 Mbps link is present.
• Blinking green—port is in 1000 Mbps ACT state,
and data is being transmitted/received.
• Blinking yellow—POST failed.
• Off—no link is present.
MOD LED
(Expansion module status
LED)
Green/yellow
• Steady green—the module is in position,
initialization completed
• Steady yellow—module initialization failed.
• Off—no expansion module is installed.
10GE interface LED Green
• On—a 1000 Mbps link is present.
• Blinking—port is in ACT state, and data is being
transmitted/received.
• Off—no link is present.