H3C Technologies H3C MSR 30 - Manual (Page 92)

84
Step5 Check that the ejector clips have locked the memory module.
Figure 86 Install a memory module
Follow the steps below to remove a memory module:
Step1 Make sure all power interfaces are shut down.
Step2 Press the ejector clips on the two sides of the memory module, and pull the memory module outwards
horizontally until it separates from the ejector clips and forms an angle of 45 degrees to the main board.
Step3 Remove the memory module.
Figure 87 Remove a memory module
Installing/removing a memory module on/from the other modules
Follow the steps below to install a memory module:
Step1 Make sure all power interfaces are shut down.
Step2 Align the connecting fingers of the memory module with the slot on the main board.
Step3 Insert the memory module into the slot in the direction of 90 degrees to the main board.
Step4 Press the edge of the memory module vertically down until you hear a click.
Step5 Check that the ejector clips have locked the memory module.