H3C Technologies H3C MSR 30 - Manual (Page 55)

47
Figure 52 Slot arrangement on the MSR 30-60
(1) Slot 0 (2) Slot 1 (3) Slot 2
(4) Slot 3 (5) Slot 4 (6) Slot 5
(7) Slot 6 (8) Slot 7 (9) Slot 8
(10) Slot 9 (11) Slot 10
Interface numbering
The MSR 30 Router interface adopts “two dimension” numbering rules, shown in the following:
• The interfaces are represented by interface-type X/Y, where interface-type can be serial,
asynchronous, ethernet or ATM, and so on; X specifies the slot number; Y specifies the interface
number.
• Different interfaces on an interface module share the same slot number X.
• For every interface, Y starts from 0 and indicates the interface sequence on the interface module,
from left to right.
If you install a MIM-1FE and an MIM-2FE respectively in slot 5 and slot 6 on the MSR 30-20, the Ethernet
interfaces are numbered as follows:
• Fixed Gigabit Ethernet interfaces are GigabitEthernet 0/0 and GigabitEthernet 0/1;
• The Ethernet interface on the FIC-1FE is Ethernet 5/0;
• The Ethernet interfaces on FIC-2FE are Ethernet 6/0 and Ethernet 6/1.