H3C Technologies H3C MSR 50 - Manual (Page 63)

55
Upgrading an Application Program Through an
Ethernet Interface
Enter 3 in the BootWare menu to enter the Ethernet interface submenu. For details about the submenu,
refer to
BootWare Submenus on page 52 .
Configuring Ethernet Interface Parameters
Before upgrading an application program through an Ethernet interface, we need to configure the
Ethernet interface on the router as follows:
Enter 3 in the BootWare menu to enter the Ethernet interface submenu. Then, enter 5 to enter the change
Ethernet parameter submenu:
==================================================
|Note: '.' = Clear field. |
| '-' = Go to previous field. |
| Ctrl+D = Quit. |
==========================================================================
Protocol (FTP or TFTP) :tftp ftp
Load File Name :host
:
Target File Name :target
:
Server IP Address :192.168.1.1
Local IP Address :192.168.1.253
Gateway IP Address :0.0.0.0
FTP User Name :user
FTP User Password :password
Table 28 Ethernet parameters settings description
Parameter Description
'.' = Clear field To clear the current field, input a (.) and then press Enter.
'-' = Go to previous field To go to the previous field, input a hyphen (-) and then press Enter.
Ctrl+D = Quit
The shortcut key combination for exiting the parameter configuration page
is Ctrl+D.
Protocol (FTP or TFTP) Select a transmission protocol, FTP or TFTP.
Load File Name
Name of the source file, which must be consistent with the actual name of
the file to be downloaded.
Target File Name
Name for the target file to be saved. By default, it is the same as the name
of the source file on the server.
Server IP Address
IP address of the FTP/TFTP server. To set a mask, separate the IP address
from the mask with a colon (:), for example, 192.168.80.10:24.
Local IP Address IP address of the local end, that is, the IP address of the FTP/TFTP client.
Gateway IP Address
Configure the gateway IP address if the server and the client are not on the
same network segment.