Bootware menu, Main bootware menu – H3C Technologies H3C MSR 50 User Manual
Page 58
50
Configure the IP addresses of both sides on the same network. In this section, the IP address of the FTP
server is set to 192.168.1.1, and that of the connected Ethernet interface on the router (GigabitEthernet
0/0 in this example) is set to 192.168.1.2. Use the ping command to check the connectivity.
Step2
Maintain the router through the terminal connected with the console interface of the router.
The following gives an example:
Trying 192.168.1.1 ...
Press CTRL+K to abort
Connected to 192.168.1.1.
220 3Com 3CDaemon FTP Server Version 2.0
User(192.168.1.1:(none)):guest
331 User name ok, need password
Password:
230 User logged in
[ftp]
Step3
Use the following commands to maintain the router.
Here, the get and put commands are used to restore and back up files.
[ftp]get main.bin main.bin
cfa0:/main.bin has been existing. Overwrite it?[Y/N]:y
200 PORT command successful.
150 File status OK ; about to open data connection
226 Closing data connection; File transfer successful.
FTP: 14323376 byte(s) received in 69.256 second(s) 206.00K byte(s)/sec.
[ftp]put main.bin main.bin
200 PORT command successful.
150 File status OK ; about to open data connection
226 Closing data connection; File transfer successful.
FTP: 14323376 byte(s) sent in 15.974 second(s) 896.00Kbyte(s)/sec.
[ftp]quit
221 Service closing control connection
After an application is uploaded to the device, you can use the boot-loader command to upgrade the
device. For the upgrade procedure, refer to
Upgrading the application programs
on page
.
BootWare Menu
Main BootWare Menu
When the router is powered on and reboots, the console terminal displays:
System application is starting...
Booting Normal Extend BootWare........
**************************************************************************
* *
* MSR50-40 BootWare, Version 1.08 *