H3C Technologies H3C MSR 50 - Manual (Page 34)

26
Console cable
Console cable is an eight-wire shielded cable. At one end of the cable is a crimped RJ-45 connector to
the console port on the router; at the other end of the cable is a DB-9 (female) connector to the serial port
on the console terminal.
The following figure illustrates the console cable.
Figure 22 Console cable
Connecting the console cable
Follow these steps to connect the router to a console terminal:
Step1 Select a console terminal.
It can be a standard ASCII terminal with an RS232 serial port, or more commonly, a PC.
Step2 Connect the console cable.
Power down the router and the console terminal, connect the RS232 serial port on the console terminal
to the console port on the router through the console cable.
Verify the connection and power up the devices. The console terminal shows the startup information of
the router if the connection is correct.
Fixed Interfaces
Ethernet Interface
100 Mbps Ethernet interface
Each MPU-G2 applied on an MSR 50 router provides a fixed 100 Mbps management Ethernet interface.
The following table describes the attributes of the FE interface.
Table 19 100 Mbps electrical Ethernet interface attributes
Item Description
Connector RJ-45
Interface MDIX autosensing
Frame format
Ethernet_II
Ethernet_SNAP
Operating mode
10/100 Mbps autosensing
Full duplex/half duplex