H3C Technologies H3C MSR 50 - Manual (Page 48)

40
Figure 36 Slot arrangement on the MSR 50-60
(1) Slot 0 (2) Slot 1 (3) Slot 2
(4) Slot 3 (5) Slot 4 (6) Slot 5
(7) Slot 6 (8) Slot 7 (9) Slot 8
(10) Slot 9 (11) Slot 10
Interface numbering
The MSR 50 Router interface adopts “two dimension” numbering rules, shown in the following:
• The interfaces are represented by interface-type X/Y, where interface-type can be serial,
asynchronous, Ethernet, ATM, and so on; X specifies the slot number; and Y specifies the interface
sequence.
• Different interfaces on an interface module share the same slot number X.
• For every interface, Y starts from 0, indicating the interface sequence on the interface module, from
left to right.
If you install an FIC-1FE and an FIC-2FE respectively in SLOT5 and SLOT6 on the MSR 50-40, the Ethernet
interfaces are numbered as follows:
• The Ethernet interface on the FIC-1FE is Ethernet 5/0;
• The Ethernet interfaces on the FIC-2FE are Ethernet 6/0 and Ethernet 6/1.