Connecting the power cord – H3C Technologies H3C S5820V2 Series Switches User Manual
Page 27
19
Connecting the power cord
CAUTION:
Provide a circuit breaker for each power module and make sure the circuit breaker is off before
installation.
Connecting the LSVM1AC650 or LSVM1AC300 power
module
1.
Insert the female connector of the AC power cord supplied with the power module into the power
receptacle on the power module.
2.
Use a cable tie to secure the power cord to the handle of the power module, as shown in
.
3.
Connect the other end of the power cord to an AC power outlet.
Figure 23 Connecting the LSVM1AC650 or LSVM1AC300 power module
(1) Cable tie
(2) Tighten the cable tie to secure the power cord to the handle of the power module
Connecting the LSVM1DC650 or LSVM1DC300 power
module
1.
Unpack the DC power cord, identify the plug for connecting to the power module, orient the plug
with the power receptacle on the power module, and insert the plug into the receptacle (see
).
The receptacle is foolproof. If you cannot insert the plug into the receptacle, re-orient the plug
rather than use excessive force to push it in.
2.
Use a cable tie to secure the power cord to the handle of the power module, as shown in
.
3.
Connect the other end of the power cord to the DC power source.