Removing a fan tray, Figure 15, Figure 16 – H3C Technologies H3C S5820V2 Series Switches User Manual
Page 23: Llout 2 in
15
Figure 15 Installing an LSWM1FANSC/LSWM1FANSCB fan tray (to the S5820V2-52QF)
Figure 16 Installing an LSVM1FANSC or LSVM1FANSCB fan tray to the S5830V2-24S
Removing a fan tray
WARNING!
•
Take out the fan tray after the fans completely stop rotating.
•
To prevent an unbalanced fan from causing loud noise, do not touch the fans, even if they are not
rotating.
To remove a fan tray:
1.
Wear an ESD wrist strap and make sure it makes good skin contact and is reliably grounded.
2.
Loosen the captive screw of the fan tray with a Philips screwdriver until it is fully disengaged from
the switch chassis.
3.
Grasp the handle of the fan tray with one hand and pull the fan tray part way out the slot. Support
the fan tray bottom with the other hand, and pull the fan tray slowly along the guide rails out of the
slot.
4.
Put away the removed fan tray in an antistatic bag for future use.