Ipv4 vrrp configuration examples, Single vrrp group configuration example, Network requirements – H3C Technologies H3C S6800 Series Switches User Manual
Page 41: Configuration procedure
33
Task Command
Display the states of IPv6 VRRP
groups.
display vrrp ipv6 [ interface interface-type interface-number [ vrid
virtual-router-id ] ] [ verbose ]
Display statistics for IPv6 VRRP
groups.
display vrrp ipv6 statistics [ interface interface-type interface-number
[ vrid virtual-router-id ] ]
Clear statistics for IPv6 VRRP
groups.
reset vrrp ipv6 statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
IPv4 VRRP configuration examples
This section provides examples of configuring IPv4 VRRP applications on switches.
Single VRRP group configuration example
This section provides an example of configuring a single VRRP group on switches.
Network requirements
Switch A and Switch B form a VRRP group and use the virtual IP address 10.1.1.111/24 to provide gateway
service for the subnet where Host A resides, as shown in
Switch A operates as the master to forward packets from Host A to Host B. When Switch A fails, Switch
B takes over to forward packets for Host A.
Figure 15 Network diagram
Configuration procedure
1.
Configure Switch A:
# Configure VLAN 2.
[SwitchA] vlan 2
[SwitchA-vlan2] port fortygige 1/0/5
[SwitchA-vlan2] quit
[SwitchA] interface vlan-interface 2