H3C Technologies H3C S6800 Series Switches - Manual (Page 33)

25
IPv4 VRRP configuration task list
Tasks at a glance Remarks
(Required.) Specifying an IPv4 VRRP operating mode N/A
(Optional.) Specifying the IPv4 VRRP version N/A
(Required.) Creating a VRRP group and assigning a virtual IP address N/A
(Optional.) Configuring the router priority and preemptive mode N/A
(Optional.) Configuring IPv4 VRRP packet attributes N/A
(Optional.) Enabling SNMP notifications for VRRP N/A
(Optional.) Disabling an IPv4 VRRP group N/A
Specifying an IPv4 VRRP operating mode
A VRRP group can operate in either of the following modes:
• Standard mode—Only the master can forward packets.
• Load balancing mode—All members that have an AVF can forward packets.
After an IPv4 VRRP operating mode is configured on a router, all IPv4 VRRP groups on the router operate
in the specified operating mode.
To specify an IPv4 VRRP operating mode:
Step Command Remarks
1. Enter system view. system-view N/A
2. Specify an IPv4 VRRP
operating mode.
• Specify the standard mode:
undo vrrp mode
• Specify the load balancing
mode:
vrrp mode load-balance
Use one of the commands.
By default, VRRP operates in
standard mode.
Specifying the IPv4 VRRP version
The VRRP version on all routers in an IPv4 VRRP group must be the same.
To specify the version of IPv4 VRRP:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter interface view. interface interface-type interface-number N/A
3. Specify the version of
VRRP.
vrrp version version-number By default, VRRPv3 is used.