H3C Technologies H3C S6800 Series Switches - Manual (Page 25)

17
• Load balancing mode—Extends the VRRP standard mode to distribute load across VRRP group
members. For more information, see " VRRP load balancing mode ."
VRRP has two versions: VRRPv2 and VRRPv3. VRRPv2 supports IPv4 VRRP. VRRPv3 supports IPv4 VRRP
and IPv6 VRRP.
VRRP standard mode
In VRRP standard mode, only the master in the VRRP group can provide gateway service. When the
master fails, the backup routers elect a new master to take over for nonstop gateway service.
Figure 8 VRRP networking
As shown in Figure 8 , Router A, Router B, and Router C form a virtual router, which has its own IP address.
Hosts on the subnet use the virtual router as the default gateway.
The router with the highest priority among the three routers is elected as the master, and the other two are
backups.
Router priority in a VRRP group
VRRP determines the role (master or backup) of each router in a VRRP group by priority. A router with
higher priority is more likely to become the master.
VRRP priorities range from 0 to 255, and a greater number represents a higher priority. Priorities 1 to
254 are configurable. Priority 0 is reserved for special uses, and priority 255 is for the IP address owner.
The router acting as the IP address owner in a VRRP group always has a running priority of 255 and acts
as the master as long as it operates correctly.
Preemption
A router in a VRRP group operates in either non-preemptive mode or preemptive mode:
• Non-preemptive mode—When a router in the VRRP group becomes the master, it acts as the master
as long as it operates correctly, even if a backup router is later assigned a higher priority.
Non-preemptive mode helps avoid frequent switchover between the master and backup routers.