H3C Technologies H3C S6800 Series Switches - Manual (Page 37)

29
Step Command Remarks
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Disable a VRRP group. vrrp vrid virtual-router-id shutdown
By default, a VRRP group is
enabled.
Displaying and maintaining IPv4 VRRP
Execute display commands in any view and the reset command in user view.
Task Command
Display states of IPv4 VRRP groups.
display vrrp [ interface interface-type interface-number [ vrid
virtual-router-id ] ] [ verbose ]
Display statistics for IPv4 VRRP
groups. display vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Clear statistics for IPv4 VRRP
groups. reset vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
Configuring IPv6 VRRP
This section describes how to configure IPv6 VRRP.
IPv6 VRRP configuration task list
Tasks at a glance Remarks
(Required.) Specifying an IPv6 VRRP operating
mode
N/A
(Required.) Creating a VRRP group and
assigning a virtual IPv6 address
N/A
(Optional.) Configuring the router priority and
preemptive mode
N/A
(Optional.) Configuring IPv6 VRRP packet
attributes
N/A
(Optional.) Disabling an IPv6 VRRP group N/A
Specifying an IPv6 VRRP operating mode
A VRRP group can operate in either of the following modes:
• Standard mode—Only the master can forward packets.
• Load balancing mode—All members that have an AVF can forward packets.