H3C Technologies H3C S10500 Series Switches - Manual (Page 80)

72
Displaying and maintaining traffic accounting
You can verify the configuration with the display qos policy global, display qos policy interface, or
display qos vlan-policy command depending on the occasion where the QoS policy is applied.
Class-based accounting configuration example
Class-based accounting configuration example
Network requirements
As shown in Figure 23 , Host is connected to GigabitEthernet 1/0/1 of Device A.
Configure class-based accounting to collect statistics for traffic sourced from 1.1.1.1/24 and received on
GigabitEthernet 1/0/1.
Figure 23 Network diagram for traffic accounting configuration
Configuration procedure
# Create basic ACL 2000, and configure a rule to match packets with source IP address 1.1.1.1.
system-view
[DeviceA] acl number 2000
[DeviceA-acl-basic-2000] rule permit source 1.1.1.1 0
[DeviceA-acl-basic-2000] quit
# Create a class named classifier_1, and use ACL 2000 as the match criterion in the class.
[DeviceA] traffic classifier classifier_1
[DeviceA-classifier-classifier_1] if-match acl 2000
[DeviceA-classifier-classifier_1] quit
# Create a behavior named behavior_1, and configure the traffic accounting action.
[DeviceA] traffic behavior behavior_1
[DeviceA-behavior-behavior_1] accounting
[DeviceA-behavior-behavior_1] quit
# Create a policy named policy, and associate class classifier_1 with behavior behavior_1 in the policy.
[DeviceA] qos policy policy
[DeviceA-qospolicy-policy] classifier classifier_1 behavior behavior_1
[DeviceA-qospolicy-policy] quit
# Apply the policy named policy to the incoming traffic of GigabitEthernet 1/0/1.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] qos apply policy policy inbound
[DeviceA-GigabitEthernet1/0/1] quit
# Display traffic statistics to verify the configuration.
[DeviceA] display qos policy interface gigabitethernet 1/0/1