H3C Technologies H3C S10500 Series Switches - Manual (Page 68)

60
Card type
(right)
SC SE EA EB
QoS-local-I
D marking Support
ed
Not
supporte
d
Support
ed
Not
supporte
d
Supporte
d Not
supported Supporte
d Not
supported
Priority marking configuration example
Priority marking configuration example
Network requirements
As shown in Figure 19 , the company’s enterprise network interconnects hosts with servers through Device.
The network is described as follows:
• Host A and Host B are connected to GigabitEthernet 1/0/1 of Device.
• The data server, mail server, and file server are connected to GigabitEthernet 1/0/2 of Device.
Configure priority marking on Device to satisfy the following requirements:
Traffic source Destination Processing priority
Host A, B Data server High
Host A, B Mail server Medium
Host A, B File server Low
Figure 19 Network diagram for priority marking configuration
Configuration procedure
# Create advanced ACL 3000, and configure a rule to match packets with destination IP address
192.168.0.1.
system-view
[Device] acl number 3000
[Device-acl-adv-3000] rule permit ip destination 192.168.0.1 0
[Device-acl-adv-3000] quit
# Create advanced ACL 3001, and configure a rule to match packets with destination IP address
192.168.0.2.