H3C Technologies H3C S10500 Series Switches User Manual
Page 41
33
[Device-maptbl-dot1p-lp] quit
3.
Configure priority marking
# Mark the HTTP traffic of the management department, marketing department, and R&D department to
the Internet with 802.1p priorities 4, 5, and 3, respectively. Use the priority mapping table you have
configured to map the 802.1p priorities to local precedence values 6, 4, and 2, respectively, for
differentiated traffic treatment.
# Create ACL 3000 to match HTTP traffic.
[Device] acl number 3000
[Device-acl-adv-3000] rule permit tcp destination-port eq 80
[Device-acl-adv-3000] quit
# Create class http and reference ACL 3000 in the class.
[Device] traffic classifier http
[Device-classifier-http] if-match acl 3000
[Device-classifier-http] quit
# Configure a priority marking policy for the management department, and apply the policy to the
incoming traffic of GigabitEthernet 1/0/3.
[Device] traffic behavior admin
[Device-behavior-admin] remark dot1p 4
[Device-behavior-admin] quit
[Device] qos policy admin
[Device-qospolicy-admin] classifier http behavior admin
[Device-qospolicy-admin] quit
[Device] interface gigabitethernet 1/0/3
[Device-GigabitEthernet1/0/3] qos apply policy admin inbound
# Configure a priority marking policy for the marketing department, and apply the policy to the
incoming traffic of GigabitEthernet 1/0/1.
[Device] traffic behavior market
[Device-behavior-market] remark dot1p 5
[Device-behavior-market] quit
[Device] qos policy market
[Device-qospolicy-market] classifier http behavior market
[Device-qospolicy-market] quit
[Device] interface gigabitethernet 1/0/1
[Device-GigabitEthernet1/0/1] qos apply policy market inbound
# Configure a priority marking policy for the R&D department, and apply the policy to the incoming
traffic of GigabitEthernet 1/0/2.
[Device] traffic behavior rd
[Device-behavior-rd] remark dot1p 3
[Device-behavior-rd] quit
[Device] qos policy rd
[Device-qospolicy-rd] classifier http behavior rd
[Device-qospolicy-rd] quit
[Device] interface gigabitethernet 1/0/2
[Device-GigabitEthernet1/0/2] qos apply policy rd inbound