Defining a class, Figure 4 – H3C Technologies H3C S10500 Series Switches User Manual

Page 25

Figure 4 QoS policy configuration procedure

Define a class

Define a behavior

Define a policy

Apply the policy

Apply the

policy to an

interface

Apply the

policy to

online

users

Apply the

policy to

a VLAN

Apply the

policy

globally

Apply the

policy to

the

control

plane

Defining a class

To define a class, specify its name and then configure the match criteria in class view.
Follow these steps to define a class:

To do…

Use the command… Remarks

Enter system view

system-view

—

Create a class and enter
class view

traffic classifier
tcl-name [ operator
{ and | or } ]

Required
By default, the operator of a class is AND.
The operator of a class can be AND or OR.

•

AND: A packet is assigned to a class only when the
packet matches all the criteria in the class.

•

OR: A packet is assigned to a class if it matches any
of the criteria in the class.

Configure match criteria

if-match match-criteria Required

match-criteria: Match criterion.

This manual is related to the following products: