H3C Technologies H3C S10500 Series Switches - Manual (Page 55)

47
To do… Use the command… Remarks
Display SP queuing
configuration
display qos sp interface
[ interface-type
interface-number ] [ | { begin |
exclude | include }
regular-expression ]
Optional
Available in any view
Configuration example
1. Network requirements
Configure GigabitEthernet 1/0/1 to use SP queuing.
2. Configuration procedure
# Enter system view
system-view
# Configure GigabitEthernet1/0/1 to use SP queuing.
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos sp
Configuring WRR queuing
Configuration procedure
Follow these steps to configure WRR queuing:
To do… Use the command… Remarks
Enter system view system-view —
Enter
interface
view
interface interface-type
interface-number
Enter
interface
view or port
group view
Enter port
group view port-group manual
port-group-name
Use either command.
Settings in interface view take effect on
the current interface. Settings in port
group view take effect on all ports in the
port group.
Enable WRR queuing qos wrr
Required
The default queuing algorithm on an
interface is SP queuing.
Configure the scheduling
weight for a queue
qos wrr queue-id group group-id
weight schedule-value
Optional
By default, the weights of queues 0
through 7 are 1, 2, 3, 4, 5, 6, 7, and 8.
Display WRR queuing
configuration information on
interfaces
display qos wrr interface
[ interface-type interface-number ]
[ | { begin | exclude | include }
regular-expression ]
Optional
Available in any view
Configuration example
1. Network requirements
• Enable byte-count WRR on port GigabitEthernet 1/0/1.
• Assign queues 0 through 7 to the WRR group, with their weights being 1, 2, 4, 6, 8, 10, 12, and
14, respectively.