Eneo NXD-2030PTZ1080IR - Manual (Page 78)

∇ RTP
Create a setting for sending and receiving an audio or video on a real-time basis. These
settings are the IP address, port number, and Time-To-Live value (TTL) to use for the media
stream(s) in multicast H.264 format. Only certain IP addresses and port numbers should be
used for multicast streams.
• Port Range
– Start/End port: Enter a value between 1024 and 65532
• Multicast (Stream1/Stream2/Stream3)
This function is for sending Video and Audio to Multicast group.
– Enable Multicast: Check the box to enable multicast operation.
– Multicast destination IP: Enter an IP between 224.0.0.0 and 239.255.255.255.
– RTP port: Enter a value between 1024 and 65532.
– RTP TTL: Enter a value between 1 and 255. If a network status is smooth, enter
a lower value. However, if a network status is poor, enter a higher value. When
there are many network cameras or users, a higher value may cause a heavy load
to the network. Consult with a network manager for detailed information.
– Always enable multicast: Check the box to start multicast streaming without
opening an RTSP session.
When the settings are complete, click Save button to save the settings, or click Reset button
to clear all of the information you entered without saving it.
78