Eneo NXD-2030PTZ1080IR - Manual (Page 45)

2) Event Out
∇ SMTP(E-Mail)
The network camera can be configured to send event and error email messages via SMTP
(Simple Mail Transfer Protocol).
• SMTP (E-Mail) Setting: Select ”Enable” to activate the SMTP operation.
– Sender: Enter an email address to be used as the sender for all messages sent
by the network camera.
– Interval: Represents the time interval of the email notification when events occur
several times.
– Aggregate events: Shows the maximum number of emails sent within each in-
terval.
– Use Mail Server: Check the box is you are using a mail server to receive event
notification and image email.
∗ Mail Server: Enter the host names (or IP addresses) for your mail server.
∗ Port: Enter the port number for your mail server. enable the sending of noti-
fications and image email messages from the network camera to predefined
addresses via SMTP.
– Enable use(SMTP) authentification: Check the box if your mail server requires
authentication.
∗ User name/Password: Enter the User name and Password as provided by
your network administrator or ISP (Internet Service Provider).
∗ Login method: Choose a log-in method in the drop-down list: AUTH LOGIN
/ AUTH PLAIN
• SMTP (E-Mail) Receiver: User can assign up to 8 receivers
– Receiver #: Enter an email address.
45