Eneo NXD-2030PTZ1080IR - Manual (Page 55)

∇ Boost
The Boost feature is used in conjunction with event detection. When this feature is turned
ON, the Frame rate and Bit rate in the boost condition can be set to a different value than
the ones in the normal condition field. When an event is detected, the camera will boost the
Frame rate and Bit rate from the normal condition to this boosted level for the duration of the
event.
Check the box to enable the service.
• Boost Setting: You can set the condition in Normal and Boost mode.
– Boot Stream: Select a video stream for each condition in the drop-down list.
– Frame rate: Select a frame refresh rate per second for each condition in the
drop-down list.
– Bit rate control: Select VBR or CBR in the drop-down list in Normal Condition.
You cant change it in Boost Condition.
– Bit rate: Select a value for each condition in the drop-down list.
When the settings are complete, click Save button to save the settings, or click Reset button
to clear all of the information you entered without saving it.
55