Eneo NXD-2030PTZ1080IR - Manual (Page 61)

• Tour Position Setup:
– Tour position: The Tour position can be selected in the range 1 - 100.
– Preset number: Show the selected Preset number.
– Dwell Time: Select the Dwell Time from 0 to 99 seconds. The default is 10
seconds.
– Speed: Adjust Pan/Tilt/Zoom Speed if you want to a slow movement. The defaults
are maximum Speed.
– Delete Position: If you want to remove Tour position from Tour Position Setup
list, select the desired Tour Position, and click the Delete Position button.
– Set Position: Click the Set Position button, then show the stored Presets or Home
on drop-down list.
Follow steps below to program the Tours:
1. Click the desired Tour position of Tour Position Setup list, and click Set Position button,
then show the saved Presets on drop-down list. Click a Preset or Home.
2. Repeat step 1 for each desired position.
3. Click the Save button to save the settings, or click the Reset button to clear all of the
information you entered without saving it.
61