ARM Electronics DVRHD - Manual (Page 68)

DVR User’s Manual
67
Appendix B: Connect Analog Camera via UTP
Converter
NOTE: The UTP Converter can provide power up to 5.5W. If the power
consumption of the camera is higher than 5.5W, do NOT connect it to the UTP
Converter.
Introduction:
The UTP converter is made especially for users who want to
build a connection between an UTP DVR and a traditional
analog camera, which allows the transmission of power and
video signal through one CAT5 cable.
The UTP converter has two cables at one end: one cable for
connecting with the camera’s BNC video connector; the other
for connecting with power jack of the camera.
A RJ-45 connector is positioned at the other end of the
converter. Connect the UTP converter and the UTP DVR using
a CAT5 cable.
Installation:
To build up an UTP connection using the UTP converter,
connect the BNC and power connectors to camera respectively,
and connect with the DVR using an Ethernet CAT5 cable.