ARM Electronics DVRHD - Manual (Page 27)

DVR User’s Manual
26
3.6.4 Record Event Video Only
If the DVR shall start recording only when alarms are triggered, follow the
steps below:
• Enter the OSD setup menu with a proper account.
• In the OSD setup menu, select menu. Move the cursor to
the item , and select .
Refer to OSD Setup Manual, Section Preset Record Configuration for
further information.
3.6.5 Per Camera Configuration
This function is used to set the Day / Night / Weekend PPS (Picture per
Second) and Quality for each channel. The Preset Configuration must be set
to for accessing these schedules. The menu is displayed as below
(Record Mode: 720×240@60PPS in NTSC / 720×288@50PPS in PAL).
Per Camera Config
Cameral Select
Normal PPS
Normal Size
Event Max PPS
Event Size
Event Active
Day
7.5
Mid
30
Best
Both
Night
7.5
Mid
30
Best
Both
CH1
Weekend
7.5
Mid
30
Best
Both
• First select a Camera for setting its record configuration. The image and
recording settings from the selected camera will be displayed on the
screen.
• Move the cursor using Direction keys and press ENTER to select an item.
• Change the value using UP / DOWN keys.
• Press ENTER to confirm the settings or ESC to abort.
• Press ESC to return to Record Setup menu.
Please note that the total normal PPS for all channels cannot exceed 60
NTSC (720×240@60PPS) / 50 PAL (720×288@50PPS). To increase one
channel’s PPS, others’ may have to be reduced first. Event PPS is not
restricted to this rule, since a smart event scheduler will handle the total PPS
with a correct weighting.