Epson C82346 - Manual (Page 38)

3 Chapter
Using Apple EtherTalk
This chapter describes how to install and configure the
Ethernet Card for use on an Apple EtherTalk network as well
as how to use the EPSON Zoner and EPSON Namer utilities.
Before using the Ethernet Card interface on an EtherTalk
network, make sure of the following:
the Ethernet Card is installed in the printer
the printer contains PostScript, which means that the
optional EpsonScript card or module must be installed.
lnstallation Overview
To set up the Ethernet Card, you will need to do the following:
Install the EPSON Zoner and EPSON Namer setup utilities.
Rename your printer using EPSON Namer.
Select a zone for your printer with EPSON Zoner.
Note:
EPSON Zoner works only on a Phase II EtherTalk network.
Using Apple EtherTalk 3-1