Alinco DJ-X3 User Manual
Page 47
47
3
Useful
Functions
o
f
the
DJ-X3
4
Press the dial (the [VOL/SQL(SET)] key) of the master DJ-X3.
Cloning starts. "Sd
" appears on the master DJ-X3's display, and
"Ld
" appears on the slave DJ-X3's display. (
changes
constantly.)
When cloning is completed, "PASS" appears on both DJ-X3s' displays.
To return to normal operation, turn the power off, and then turn it on again.
Caution!
· Do not disconnect the cable while cloning.
· All data in the slave DJ-X3 will be updated if cloning is executed. Be
careful with current data on the slave side before cloning.
· If you disconnect the cable or turn off the other DJ-X3 after "PASS" was
displayed, "comErr" will appear on the display; however, cloning has been
executed normally.
If "Error" appears on the display...
If incorrect data is transmitted while cloning, "Error" will appear on both DJ-X3s'
displays. Press the dial (the [VOL/SQL(SET)] key) down on the master DJ-X3 to
restart cloning. If "Error" appears on both DJ-X3s' displays once again, it is not
possible to transmit data as it may be incorrect data.
(Slave)
(Master)