Alinco DJ-X3 - Manual (Page 26)

2
Basic
O
peration
26
■
Program Scan
This function scans a specified range of frequencies. Before using this function,
you need to specify the upper and lower frequency limits. These frequencies
are called a "Program scan channel", and the DJ-X3 has 20 pairs of program
scan channels. Set the combination of upper and lower limits. (i.e. A00 and
B00, or A01 and B01) For more information, see "Programming a Channel."
(P.23)
1
Switch to the VFO mode by pressing the [V/P/M (MW)] key.
2
Press the [SCAN(SCRT)] key.
3
Rotate the dial while holding the [SCAN(SCRT)] key, and select a pair
of programmed channels to be scanned.
Frequencies between A and B of the same No. will be scanned.
4
Release the [SCAN(SCRT)] key.
Program scan starts. ". (decimal point)" flashes, and "PS" appears on the
display. Scanning pauses when a signal is received.
Tip
The tuning step and modulation mode of the Program scan function are the
same as those set for the VFO mode (not the memory mode).
Program channel No.
Flashes
POWER
SCAN
SCRT
V/P/M
MW
BANK
WIDE BAND
COMMUNICATION RECEIVER
DJ-X3
1M/10M
1
3
2,3,4