Alinco DJ-S45 - Manual (Page 41)

40
8.Cloning / Packet Operation
8
Transmitting the Master Data
1. Press and hold the MONI key and press
the PTT key three times.
"CLONE" appears on the display to
indicate the Clone mode is activated.
2. Press the PTT key on the master unit.
"Sd ***" is displayed and the data-
transfer starts.
"PASS" appears when the cloning
completes.
Turn the power OFF after "PASS" is
displayed.
If the data is not transmitted correctly,
"PASS" is not displayed. Turn the power
ON again, and repeat the procedure from
step 1.
3. To cancel the Clone mode, turn the power
OFF.
Cloning completed
■
Caution
If the cable is not connected correctly, "Err" appears on the
display.
Check the cable connections again.