Alinco DJ-S45 - Manual (Page 36)

35
6.Advanced Operations
6
6-4 Tone Call (Tone Burst)
Use this function to call a partner by adding an audible tone to the
transmitting signal.
The tone signal is output while the MONI key is pressed down while
the PTT key is pressed and held. The call tone sound can be selected
in the Setting mode (page 24, ITEM No.05).
Use this function to access tone burst system repeaters by selecting
proper tone.
6-5 Channel Display Mode
This mode is to display the memory channel number only in memory
mode operation.
Prior to use this mode, please program the memory channel(s).
1. Turn off, then turn on with both and
keys pressed.
2. Repeat the same sequence to return to the
original display indication mode.
3. Please note that in this status the operating
parameters are only limited to those
programmed in memory and the access to
the Setting mode becomes disabled. Go
back to the original display indication
mode to change the parameters.
▼
▲
Caution
A tone call signal cannot be output with a tone ENC signal.
During call tone output, the ENC signal cannot be transmitted.